Jump to content

Reset to automatic determination of the inverter PNom limitation mode


Recommended Posts


We have just switched from v. 7.3.2 to 7.4.4.  We like the new feature where PVsyst reads the correct inverter PNom limitation mode for power factor implementation, since we were checking and inputting this manually.  We see that when we start a new project, the correct mode is shown and neither of the "PNom mode derogation" options is selected.  However, when we load an existing project, there is always one selected.  While we can then toggle back and forth between the two options, there doesn't seem to be any way to ask for the option to be automatically set based on the OND specs.  That is, one or the other boxes will always be selected.  Question:  Is there a way to reset this selection?  It might not matter, but giving someone an unneeded option is always leaving room for error.



Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Create New...