alsolar Posted February 23, 2014 Share Posted February 23, 2014 Hello. When I try to do a simulation (tools > measure data analysis ), and I load the corect project, when I click in "Site and Meteo" I see the correct Project Site. However, below at the "System Variant" section, in the "meas. data" dropdown, I only have a choice to select a .DAM file from Geneva, so I am not able to run the Simulation with the correct Site. How do I attach the correct Project Site into the "meas. data" drop down? Do I have to convert my Site.MET file into DAM? How do I do that properly so that I can use the correct .DAM file on the Simulation? Thanks and Regards, Al Link to comment Share on other sites More sharing options...
André Mermoud Posted February 25, 2014 Share Posted February 25, 2014 This is not the right place for performing PVsyst simulations. You should use (on the main page) : "Project design" / "Grid connected". Here you are in a special (advanced) tool for the analysis of data measured on a PV system. DAM files are meteo files including additional measured data about your system (for example output energy). Link to comment Share on other sites More sharing options...
alsolar Posted February 26, 2014 Author Share Posted February 26, 2014 Many thanks! It works now. Regards Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now