Orientation problem

[Swonno]

Good afternoon from Korea. Can I have a question?

 

The Orientation update button doesn't run. So I moved to the Orientataion management tool and changed til 5degree but It seems like it`s not working.

 

The Mesh #14 is the flat modules wich is 0degree.

What can I try next? Pls help thanks.

[Swonno]

I adjusted tilt management degree and it works not thanks!!

[Swonno]

 

Is there any tips to run the simulation? Because I succed to arrange various orientations but even small capacitiy orientation is needed to same inverter but this inverter is too oversized for this. I didn't expect this small capacity orientation.... Do you have any guide line at this situation???

Inverter size is planned for 125kW but I desized to 50kW but i can see error. 

Edited November 7 by Swonno

[Muhammed Sarikaya]

Dear Swonno,

 

You can modify the limit parameter to allow PVsyst to run the simulation.

 

Got to "Settings-Edit advanced parameters"

In the search box, type "inverter" and find the line "The Inverter power is strongly oversized." Adjust the ratio to, for example, 0.1 as follows:

This will enable you to run your simulation. Don’t hesitate to reach out to us if you have any questions.

Regards,

Muhammed Sarikaya