DanielE

Dear André, unfortunately the button "set all modules" is not working in my case. Please see the screenshots below. The default setting for this table is shown in the second screenshot. The modules are arranged horizontally so that 39 modules are placed on the table. I changed these settings and according to the first screenshot. The modules are arranged vertically and 44 modules are place on one table. I pushed the "set all modules" button for table no. 2. After that i had to change the mecanical settings for every other table again. I hope this example helps you to solve the problem. Thank you and best regards, Daniel

Hello, It would be desirable to have a button in the "Module Layout", which has the function to apply a defined layout respectively the defined mechanical layout parameter of one table for all module tables. Currently you have to do the module layout definitions for each table. Thanks in advance, Best Regards, Daniel

Hello Derek, Try the following settings - it should work then.

For *h2p-file imports for PV plants in the southern hemisphere in "near shadings" the module tables are placed irregular and overlapping each other, and alternately aligned to south and north.

I do a simulation using the Hay transposition model for the calculation of the incident irradiance on a tilted plane and save the project. The transposition model is mentioned in the report (if activated under preferences). I leave the project, change the transposition model to Perez and open the project again. Now, when i am going to open the report again - without doing the simulation again - the transposition model mentioned in the report is Perez but the results of the report have been caclulated with Hay. In my oppinion this problem should be solved, because if there are several users at one workstation, changing the transposition model, there might occur some missunderstandings.