Hello, I am trying to define a thin-film PV module that has a cell width of 7 mm and a length of 290 cm. However, when I get to the definition of the cell area I get some weird comments. Firstly I get this popup saying that the cell area has an invalid character because the software has put a '*' inside.
This does not allow me to leave the Sizes and Technology tab at all.
Then if I try to define the cell area as 203 cm^2, I get a pop-up saying that the "cell sizes determination is not applicable", and I do not understand what is meant with that.
Then if I try to define the cell width as 7 mm, the cell area is changed to '*100000000' again (not sure on the exact number of 0's) and I get the same popup again
However, if I leave the tab after defining the area as 203 cm^2 then even though I get this strange error, the cell efficiency is properly calculated and it seems to work fine but I don't understand why these errors are popping up.
