Good morning everyone,
I have drafted on Autocad a preliminary layout of a rooftop PV syst.
According to the available surface on each roof pitch, on some orientations it is possible to put a number of PV modules which is not divisible by any number (aka prime number).
As you can see in the table down below, you can actually install 173 PV modules,South West oriented.
Nevertheless, 173 is a prime number, so when it comes to put that value in the "system definition section" on PV syst , I am not able to create a sub array called "South West" with 173 modules, as this cannot be calculated as "nr of modules in series X nr of strings".
May you kindly suggest how to proceed in this case?
Thank you a lot!!
