The difference between the azimuth of the field and of the average orientation too high error

[Pranav]

Hello Team,

As you can see below. I am getting the error for the differnce between the azimuths as well with the error average orientation is too high. As the average is in minus, how I can i change the other limitations in the Project setting.

Thank You.

Regards,

Pranav

[Jeremie]

Hello, the parameter you're looking for is Param_Azim Spread Max. You can find it in the category 'Verifications on General system parameters'

[NGD]

Hello, 

 

I have a similar error, but my question is what value to introduce in the parameters in the case I have both negative and positive values (I am working with and EW system). When I introduce a negative value in the parameters, the error only shows for those field with positive values, and viceversa. 

Thank you for the help!

[Jeremie]

Hello NGD. The parameter is a positive value. The absolute value of the angles difference is checked against this parameter.

My guess is that in the first case (15 - 12.6) you set a value that was sufficient to accept this difference, but not in the second case (109.9 - 93.6 = 16.3) Please check again

Edit: Your error actually refer to parameter 'Tilt Spread Max'