LID in v6.80

[Christina_Ng]

Hello,

Just upgraded to v6.80 and ran a simulation. I noticed that even though I've inputted LID in Detailed Losses, it becomes 0 and does not show up in the report at all nor in the loss diagram. When I go back to Detailed Losses, LID is set to 0.

Any one having the same problem?

Thank you,

Christina

[dtarin]

Sorry for the late reply here, just saw this. It appears HIT is classified as an unconventional technology, to which LID does not apply. It seems LID is only applicable to c-Si technology in PVsyst. Panasonic HIT modules (for example) state low LID, but not zero LID. I would suggest accounting for LID loss in the module quality factor loss.