PVsyst's forum

Welcome on PVsyst's forum.
It is currently Sat Sep 19, 2020 4:34 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Thu Jul 02, 2020 10:09 pm 

Joined: Sat May 26, 2018 12:06 am
Posts: 1
Hi
i am modelling a system with fixed tilt sheds where the *.shd file insists to add a parameter "PitchSlope=90.0", the shed-to-shed slope (it's a parameter of the PV_Object pvShdArraySunShield).
  • If i manually replace the value to "PitchSlope=0.0" in the *.shd file, the model opens just fine.
  • After i close the variant and save it the parameter disappears in the *.shd file.
  • When i open the model again and start the near shading module, all sheds are "stacked" with the 90° slope. If i save again, the above mentioned parameter appears again.
This happened in one other model i did some time ago but i cancelled the project and discarded it. So i ignored. It did not appear in the ~15 other projects i modelled in between...

I am using plain ground with a ground image (*.pgn) (no ground model) and no pitch slope actually.

I'd appreciate some help because it was a nasty piece of work to place the sheds in this one...


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited