PVsyst's forum

Welcome on PVsyst's forum.
It is currently Sat Dec 07, 2019 3:48 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: LID in v6.80
PostPosted: Wed May 22, 2019 5:57 pm 

Joined: Fri Jan 25, 2019 2:49 pm
Posts: 5
Hello,

Just upgraded to v6.80 and ran a simulation. I noticed that even though I've inputted LID in Detailed Losses, it becomes 0 and does not show up in the report at all nor in the loss diagram. When I go back to Detailed Losses, LID is set to 0.

Any one having the same problem?

Thank you,
Christina


Top
   
 Post subject: Re: LID in v6.80
PostPosted: Tue Aug 13, 2019 8:28 pm 
User avatar

Joined: Tue Oct 18, 2016 3:31 am
Posts: 227
Sorry for the late reply here, just saw this. It appears HIT is classified as an unconventional technology, to which LID does not apply. It seems LID is only applicable to c-Si technology in PVsyst. Panasonic HIT modules (for example) state low LID, but not zero LID. I would suggest accounting for LID loss in the module quality factor loss.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited