PVsyst's forum

Welcome on PVsyst's forum.
It is currently Wed Dec 01, 2021 10:47 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
 Post subject: MPT Losses in 7.0
PostPosted: Tue Oct 19, 2021 7:42 pm 

Joined: Tue Oct 19, 2021 7:26 pm
Posts: 1
Hello,

I am currently modelling a site utilizing both monofacial and bifacial modules. Inverters are only powered by Mono or Bifacial modules, no mixing. Based on how PVsyst runs the 3D shading, a different variant is required for the monofacial and bifacial sections. As site has to be split into two separate simulations, MPT nominal power, Iron losses (NL loss), and Copper (resistive loss) loss at PNom need to be scaled down based on percentage of site power produced by each section. To avoid this scaling, I want to apply HV Transformer losses and Grid Limit post simulation (after EMVOhmL) in an excel file to determine E_Grid at the POI. Is there a formula used in PVsyst simulation that could be inserted into the excel file to apply the HV Transformer Data Sheet values from ohmic losses tab the same way that PVsyst would apply them in its simulation?

Thanks,


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited