PVsyst's forum

Welcome on PVsyst's forum.
It is currently Wed Oct 27, 2021 11:12 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Sep 21, 2021 9:26 pm 

Joined: Tue Sep 21, 2021 8:50 pm
Posts: 1
I am a newbie on this . I was trying to understand few things on detailed computation of mismatch (Loss section that uses RMS of Voc and Isc).
As I am seeing the help section , the IV curves are based on single diode model that has following parameters :
I = Current supplied by the module [A].- Unknown
V = Voltage at the terminals of the module [V].- Unknown
IphRef = Photocurrent [A]
IoRef = diode inverse saturation current [A]
Rs = Series resistance [ohm].
Rsh = Shunt resistance [ohm].
Gamma= Diode quality factor, theoretically between 1 and 2, often less
q = Charge of the electron = 1.602·E-19 Coulomb
k = Bolzmann's constant = 1.381 E-23 J/K.
Ncs = Number of cells in series.
Tc = Effective temperature of the cells [Kelvin]

As I understand we get IV curves from this equation .Now looking at the detailed computation, It uses RMS values of Voc and Isc and obtains statistical sample of Voc and Isc . It then uses them in generating IV curves after aligning Voc and Isc (summing etc) . But, As I see the single diode equation has these two parameters as unknown that is calculated from the photocurrent IphRef. I am not able to relate this part . How we are generating the new IV curves from the statistical sample . Are we using this same single diode equation to generate IV curves here or some more info is there? Or I am interpreting things incorrectly ??


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited