PVsyst's forum

Welcome on PVsyst's forum.
It is currently Thu Sep 24, 2020 7:33 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Oct 15, 2017 6:41 pm 

Joined: Sun Oct 15, 2017 4:03 pm
Posts: 1
I use the central inverter in a mountain-mounted power plant, how to set the figure of azimuth to get a more accurate simulation result due to the table has different azimuth? Thanks.


Top
   
PostPosted: Wed Nov 15, 2017 12:56 pm 

Joined: Sat Oct 28, 2017 7:57 am
Posts: 1
The problem of mountain solar plant modeling and simulation
Hi, our company has a project in India, it's a mounting solar plant, the installation condition is quite severe. In our project, we used 280W PV module, 22 PV modules as one string, 180 strings in total ( Around 1 MW DC Capacity). The slope of the fixed rack is 36°, and the azimuths of panels in this project was simplified as 20 PV strings westward 10°, 20 strings westward 5°, 20 strings westward 3°, 60 strings southward, 20 strings eastward 3°, 20 strings eastward 5°, and 20 strings eastward 10°.
To simulate the influence based on variety of azimuths, we established a simulation model in which the seven sub arrays were set according to the assumption of azimuth.
The simulated PR is 83.33%. However, according to the real PR ratio, the simulation result seems quite inaccurate, because the simulation can not include the loss of the mismatch from different azimuths of strings. So I am wondering to know if anyone has meet the same question and how to set these parameters under such conditions?


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited