PVsyst's forum
https://forum.pvsyst.com/

Incident angle parameter in output file
https://forum.pvsyst.com/viewtopic.php?f=25&t=1168
Page 1 of 1

Author:  stefm [ Thu Aug 29, 2013 11:35 pm ]
Post subject:  Incident angle parameter in output file

Hi,

I upgraded to the newest version of PVsyst (6.11) and could not find a parameter that could previously be written to the simulation output file. Incident angle used to be a parameter in the "Incident energy factors" category. Has it been removed from the output file parameter list, and if so, is there an alternative parameter from which I can easily calculate the incident angle? For reference, this was with a tilted single axis tracking system with a tilt angle of 0 degrees, with a defined shading scene. Thank you!

Author:  AndrĂ© Mermoud [ Fri Sep 06, 2013 6:54 pm ]
Post subject:  Re: Incident angle parameter in output file

It has perhaps been removed by mistake, I don't know.
I will reintroduce it for a next version.

Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/