PVsyst's forumhttps://forum.pvsyst.com/ Project settings, shadingshttps://forum.pvsyst.com/viewtopic.php?f=24&t=4920 Page 1 of 1

 Author: tecnun [ Mon Jun 15, 2020 3:25 pm ] Post subject: Project settings, shadings Hello good day, I would like to know exactly the difference between these shading conditions in Project Settings: - Discriminating orient difference between shading planes - Maximum orient difference for defining average spread orientation What do they stand for? For instance, I am working with shading scenes imported from T3 in a non-flat terrain (real topo scene). By default the system brings me to define +8 orientations. But I would like to define 3-4 main orientations and distribute them in 3-4 subarrays (unless terrain is very flat, which i prefer to define 1 average orientation-slope) Dont know if i have explained... BR Jose M (tecnun)

 Author: dtarin [ Wed Jun 24, 2020 1:06 am ] Post subject: Re: Project settings, shadings - Discriminating orient difference between shading planes I believe this can be thought of as the resolution to which PVsyst will define a unique orientation based on the difference with other sheds - Maximum orient difference for defining average spread orientation This parameter will be used to define the range for which an average value will be calculated and used for transposition. See: viewtopic.php?f=3&t=2524&p=6730&hilit=D ... anes#p6730

 Author: tecnun [ Wed Jun 24, 2020 12:51 pm ] Post subject: Re: Project settings, shadings Thanks Dtarin, I m getting now the discriminating factor, eg if you have only 2 tables and they differ each other 1° if you choose 2° the system will consider them equal, but if you set it to 0,5° there will be 2 different orientations. Concerning the other condition i stll have doubts. So if, going to the hereabove example, you add a third table wihich differs the other 2 more than 10° and you choose limitation of 10° what happen? BR Tecnun

 Page 1 of 1 All times are UTC+02:00 Powered by phpBB® Forum Software © phpBB Limitedhttps://www.phpbb.com/