PVsyst's forum
https://forum.pvsyst.com/

Can't simulate mixed orient sub-arrays by optimizer and 3D model
https://forum.pvsyst.com/viewtopic.php?f=24&t=4671
Page 1 of 1

Author:  norin [ Fri Jan 31, 2020 11:21 am ]
Post subject:  Can't simulate mixed orient sub-arrays by optimizer and 3D model

I use PVsyst V6.78 version.

I would like to simulate the mixed orientation sub-arrays by 3D model
to use 1x1000kW inverter(1xmppt) connected two types of orientation sub-arrays without/with optimizers.

When I simulate without optimizers, I can select the ratio of Orient#1 and Orient#2 in "System" menu,
which shows scroll bar to modulate the ratio.
I also made two table zones and set modules in 3D model in "Near Shading" menu to fit the same ratio of orient #1 and #2.
It worked.

However, when I simulate with optimizers(string type optimizers),
the scroll bar to modulate orient#1/#2 does not display.

Is there any method to calculate 1xinverter(1xmppt) connected two types of orientation sub-arrays with optimizers in 3D model?

Author:  dtarin [ Sat Feb 08, 2020 12:01 am ]
Post subject:  Re: Can't simulate mixed orient sub-arrays by optimizer and 3D model

What is the equipment you are using?

Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/