PVsyst's forum

Welcome on PVsyst's forum.
It is currently Fri Sep 20, 2019 9:42 am

All times are UTC+02:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Aug 23, 2019 9:17 pm 

Joined: Sat Jun 08, 2019 12:01 am
Posts: 2
Hello All,

Does anyone know what parameter in a .pan file would cause a linear vs non-linear behaviour in the max power point of a module vs temperature in the one-diode model calculated by PVSyst? I have 3 modules from the same manufacturer that behave differently, 2 modules will have a linear behaviour and their maximum power point will increase with a decrease in temperature. The last one will behave linearly up to a point (about -10C), and then its power will start decreasing with temperature instead of increasing. I've checked a few more .pan files and about 45% of them have this non-linear behavior as well, all starting to decrease in power at around -10C.

Does anyone know how PVSysts decides to correct for temperature in a linear vs non-linear way? I looked at the .pan files, but no parameter really stood out that might isolate the modules with a non-linear performance, so I assume it might not have to do with the .pan file parameters and have more to do with PVSysts methods of correcting for temperature. If anyone has a potential answer to this, I'd greatly appreciate an explanation

Thanks,


Top
   
PostPosted: Thu Aug 29, 2019 11:23 pm 
User avatar

Joined: Mon Apr 16, 2012 7:29 pm
Posts: 1608
This is an artefact of the one-diode model.
For numeric reasons, I had to limit the Diode Saturation current at a threshold value of 0.01 pA. When limiting to this value, the muPmpp becomes positive.
This arises at very low temperatures, when you define a Rseries value close to its maximum RSMax.

I judged that below -10°C, this remains acceptable. By the way even if the muPmpp becomes positive the one-diode model still works correctly. Simply the Pmpp doesn't increase anymore when going towards lower temperatures.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+02:00


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited