PVsyst's forum
https://forum.pvsyst.com/

Defining Partitions Across Multiple Tables
https://forum.pvsyst.com/viewtopic.php?f=12&t=4465
Page 1 of 1

Author:  dtarin [ Wed Jun 19, 2019 1:55 am ]
Post subject:  Defining Partitions Across Multiple Tables

Hello,

It is currently a shortcoming in PVsyst when defining a table size less than the width of the string (when defining partitions), as this results in lower electrical effect losses. It is not always possible to define a table size one string in width, such as cases where sites contain complex undulations or unique geometries, and a smaller table size is needed. The module layout method does not always work (viewtopic.php?f=4&t=4334), nor is it applicable to large sites. Development to address this shortcoming by allowing smaller tables to be joined into one string would be much appreciated.

Page 1 of 1 All times are UTC+02:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/