Incoherence in simulation results Nominal array energy balance error (5.22%) / Simulation of Domes

[Saurabh]

Hello PVSyst team,

This error occurred when I was trying to simulate domes, unfortunately, I could not assign the 3D area to the subarrays I had defined in System. Then I defined two fixed tilt orientations imitating the domes. I am not sure if it's the right way to simulate. Please guide or give your input on this method to simulate the domes and what needs to be done to resolve the error attached.

Thank you for your help in advance.

Best,

Saurabh Pansare

[Michele Oliosi]

This does not seem related to the domes, actually. This type of error usually stems from how the module has been defined.
However, the exact cause cannot be known from the message alone. There can be multiple reasons for it.

If you could export and send us the project at the email written in the message, it would allow us to take a deeper look and find the underlying cause.
Thanks in advance !

[Saurabh]

Hello Michele,

Thank you for the prompt reply. The error disappeared after changes in the System tab. However, I would like to know if it is the right way to simulate domes' (East West) orientation. I have sent the project to the email address mentioned.