PVSYST REPORT : GCR decimal points

[tea]

Hi Guys, 

 

i am using PVsyst 7.4.0

Typically, in the pvsyst report in the general parameters page, I see that the GCR is one decimal place. I was wondering if it is possible to change to 2 decimal points ?

[Michele Oliosi]

It is not possible currently sorry. Note that a second decimal place means between 0.01% and 0.1% depending on the GCR. This is well below the usual precision of the simulation; moreover, isn't this well below the typical significance of geometric measurements?